7.5 Inch Aluminum Housing LED Tail Lights - 2 PCS Red 36-LED Running Brake Turn Signal Marker Lights for Trucks, Trailers & Motorcycles - Waterproof & Durable

Product Description

About this item

• Super Bright LED: Equipped with 36 pcs ultra bright 2835 SMD LEDs. outputting two levels of brightness red light. High brightness is for brake light/turn signals light. Low brightness is for running light/tail light/marker light. Ensure a better visibility and safety at day and night
• Aluminum Housing: Compared to plastic shells. aluminum shells can accelerate heat dissipation. improve the service life and performance of the entire light. And there is no need to worry about the bottom shell breaking due to excessive force during installation
• IP67 Waterproof: The PC lens and aluminum shell are tightly fitted. with an internal sealed waterproof design. At the same time. glue is also added to the wires position on the back. Reaching IP67 waterproof level. lights can be used in rainy and snowy weather without worrying about water ingress
• Surface Mount: Comes with necessary washers. bolts. and nuts for installation. The installation can be completed in ten minutes. Each light has a foam pad. which can be used to mark the positions that need to be drilled. The foam pad can also effectively protect the surface of the car
• Widely Used: Fit for almost 10-30V DC Vehicles. such as trucks. trailers. tractors. semi-trailer. horse trailer. travel trailer. dump Truck. camper. RVs. bus. boat. special vehicle. etc
  

Key Features

Accelerated Heat Dissipation

The tail light bottom shell is made of aluminum material. which can better accelerate heat dissipation while ensuring durability. thereby improving the service life and performance of the entire light.

Sealed IP67 Waterproof

At the same time as internal sealing. glue is injected into the back wire position to form a full seal. Prevent moisture from entering and lights can be used in any weather.

Easy To Install

Comes with necessary washers. bolts. and nuts for installation. Each light has a foam pad. which can be used to mark the positions that need to be drilled. The foam pad can also effectively protect the surface of the car.

Wire Connection

White wire with O ring for ground. black wire is for low brightness running light/tail light/marker light. And red wire is for high brightness back up/reverse light.

Application